Kategorie: Etagensortierung EN

Sortieren EN Sorting

Maximum wood protection

Careful material handling and space saving

BUFFER LEVEL SORTER

Use of a buffer level sorter always makes sense where timber should be sorted with as much care as possible, but the sorter should not require excessive space. Nevertheless, the space required by a buffer level sorter is greater than that for a box sorter, as an emptying section must be provided after each level. As the timbers in the levels lie loosely on top of each other and need to be separated prior to filling and after emptying, this sorter is only conditionally suitable for planed workpieces.

Sortierung_Pufferetage

Ideal for planed workpieces

FILM LAYER SORTER

A film layer sorter takes up a lot of space, as the levels are arranged one above the other. However, it is ideal for careful sorting of classified planed timbers, as each board film lies individually in the levels and need not be separated again after emptying. This enables subsequent stacking of the layers and a maximum stacking capacity.

Sortierung_Filmetage

Timber product assortment

IDEAL LAYER LENGTH

The number of assorted products determines the number of levels, and the required length of a level is determined by the cross-sectional size of a package. Filling and emptying of the levels occurs fully automatically in each case.

Entstapeln EN Destacking

Separation of single and multiple packages

High performance and a high cycle rate

TILT DESTACKING

For separating single and multiple packages with and without intermediate sticks upstream of planing and sorting systems. The packages are received in a transverse direction by a lifting unit, pivoted through approx. 45° and conveyed on to the skid edge. Layer by layer, the timber pieces now slid over a skid edge (which can be flexibly adjusted) to even out distortions in the layer.

Entstapeln_Kippenstapelung

Minimising setup times

TILT DESTACKING OF DOUBLE PACKAGES

Tilt destacking of double packages can halve setup times, minimising production costs as a result. The intermediate strips in double packages can be removed with the aid of a stick stripper (optional) and collected and sorted for further use or disposal.

Entstapeln_Kippentstapelung_Mehrfachpakete

Careful and gentle at a medium cycle rate

VACUUM DESTACKING

Vacuum suckers lift the topmost layer of a package and deposit it gently in a transverse direction on the conveyor. This careful handling is particularly suitable for avoiding surface damage to planed workpieces. The vacuum destacker is suitable for production lines with short to medium cycle rates.

Longitudinally and transversely at a low cycle rate

PUSH-OFF DESTACKING

This destacking involves pushing the uppermost layer of a package to the downstream process. Pushing can occur in a transverse or longitudinal direction, depending on the space requirement. This destacker is used on production lines with a low cycle rate.

Entstapeln_Kippentstapelung_Abschiebeentstapelung